W

G

=

G

1

+G

2

G

*100                                            (1) 

where G1 - weight gain basic tube with magnesium chloride, g; 
G2 - weight gain control tube with magnesium chloride, g 
G - weight of fuel, g 
This method gives sufficiently accurate results. 
Direct volumetric moisture content made by heating coal sample with toluene, 

stripping water vapor are released from coal with toluene vapor and metering volume 
condensed water. Moisture and brown coal, anthracite and oil shale sample is 
determined by drying fuel 105-110 ° C to constant weight in the oven. The loss in 
weight taken at the same time for the moisture content of the fuel. To determine the 
moisture content in pre-weighed weighing bottle height of 25-30 mm and a diameter 
of 35- 40 mm weighed on analytical weight 1-2 g researched fuel (up to 0.01 g), 
particle size which does not exceed 0.21 mm (analytical sample). The height of the 
layer of fuel in the cup should not be more than 5 mm. Light weight is spread by 
shaking and dried in a preheated oven at 105-110 ° C. 

Duration of brown coal drying for 90 min., Anthracite - 120 min.; other fuels - 

50-60 minutes. After passing the specified time cup with a sample of fuel removed 
from the cabinet, cover tightly, cooled first in air (2-3 min.) And then in a desiccator 
to room temperature and weighed. Then again weighing bottle with the sample put in 
the oven and dried for 30 min., Cooled in a desiccator and then weighed. Drying and 
weighing is repeated until constant weight. Deviations shall not constitute 0,0002 g If 
the observed increase in weight due to oxidation of coal, for the calculation are the 
penultimate weight [5]. 

The percentage of moisture in the test fuel is calculated using the formula: 

 W=

a-b

a

*100                                                  (2) 

where and - the weight of fuel, g; 
b - mass of the residue after drying, g 
Allowable discrepancy between two parallel definitions no more than 0.3%. 

Calculation of the analysis leading up to 0,01%. 

Determination of ash. 
Mineral admixtures that form ash is even more harmful ballast composed of fuel 

than wet. In addition to non-productive costs for transportation, reloading, etc., high 
ash coal greatly complicates its use as an energy fuel and as chemical raw materials. 
Mineral admixtures fuel combustion change their original composition and properties. 
Burning coal with high ash content associated with frequent cleanings furnaces. When 
using high ash coke in the blast furnace process increases not only the separation of 
the coke, but fluxes that go on ash slagging. Forms and sources of ash in the solid fuels 
are very diverse. 

- 75 -