The determination of tendency to deformation aging for cold-worked products has 

its own specifics, which is partially covered in the work [26]. Here we note only the 
following main differences from the standard specifics.  

1. The degree and the scheme of the cold deformation are not actually conditional, 

but are specified by the deformation parameters for manufacturing a cold-worked 
object-product. 2. Deformation aging should be carried out as a stress deformation 
aging (based on the operating conditions of the product), duration and temperature are 
set, as the relevant statistics are gathered for the products of this class. 3. The same 
statistics are needed to determine the permissible values of properties of the 
deformation-aged product, under which the process of deformation aging of the 
product during operation in a given time interval does not lead to a loss of the load-
bearing capacity of the product. 4. It is also clear that the deformation aging of the cold-
worked product according to the described scheme and its results are closely related to 
the possibility of adjusting the tendency to deformation aging in one way or another 
[26-29]. 

Figure 1 below graphically presents the developed variants for the technological 

schemes for manufacturing steel products hardened by cold deformation with the use 
of the new principles for the formation of structural states with a high density of linear 
and two-dimensional defects of the crystal structure. 

 

Figure 1. The variants of the technological schemes for manufacturing steel 

products hardened by cold deformation

 

 

- 1697 -