Kurpe O. 
Doctor of Philosophy, Chief Expert, METINVEST HOLDING, LLC, Mariupol, 

Ukraine 

Kukhar V. 
Doctor of Sciences, Professor, Head of Metalforming Department, Pryazovskyi 

State Technical University, Mariupol, Ukraine 

 

DEVELOPING OF MANUFACTURING TECHNOLOGY FOR HOT 

ROLLING COILS (STEEL GRADE S355MC) AT THE WIDE-STRIP 

ROLLING MILL 1700

 

 

Introduction. Widely known advantages of the rolled product manufacturing 

with the use of

 

thermo-mechanical controlled process (TMCP). Increase in the 

customer demand for the products, which are manufactured in compliance with the 
abovementioned technology, makes domestic producers to master their production. 
The product mix, which can be manufactured, directly depends on the producer’s 
equipment characteristics and composition, in other words, it is important to 
preliminary make technical and technological assessment of the potential for TMCP 
technology implementation into production. Indeed, the operating conditions in the 
companies manufacturing rolled products [1] can be a very important factor for 
increasing competitiveness of steel products in European markets. It should be noted 
that the domestic hot rolling coil mills were constructed much earlier than the 
thermomechanical rolling technology was widespread. Therefore, this technology and 
products are not designed and shall be implemented in a phased manner.  

Problem definition. The paper objective is to develop manufacturing technology 

for hot rolling coils up to 6×1500 mm (steel grade S355MC) in accordance with EN 
10149-2 at PJSC ILYICH IRON & STEEL WORKS OF MARIUPOL (Mariupol), 
without equipment upgrading.  

Review of recent studies and publications. The diffusion of the thermo-

mechanical controlled process (TMCP) technology in the world commenced during the 
1960’s of the last century [2]. In our country, this technology was introduced 10 years 
later [3]. During the period of implementation, TMCP technology has evolved, and 
relevant equipment has also undergone significant changes [4-6]. Currently, this 
production practice presents the greatest potential and is constantly developing.  

Nowadays, TMCP is used to manufacture the rolled products for various 

structures and construction, pressure vessels, pipelines of plates and coils. The results 
of its intensive study are presented in many papers of the international authors [4-18].  

If earlier TMCP was predominantly used to manufacture the rolled products from 

low carbon steel grades [14, 15], steels, in which the carbon content is 0.40% [19], 

- 1719 -