According to Table 1, considerations built with the proposed gradation velocity 

modulation, which may be subject to reduction, where "+" marked those stairs that 
recommended to remain, and "-" â€“ those that recommended to exclude.  

Also, when calculating the propagation areas, the maximal propagation radius of 

modulation QAM-256 should be taken into account since it serves relatively small area, 
but for mobile base stations this modulation is too powerful. The final set of selected 
modulations is shown on Fig. 8 in form of distances from base station. 

Let’s calculate a total system productivity. This will allow to exclude some some 

code rates for MCS. The calculated throughput with excluding some unnecessary code 
rates, and with excluding the QAM-256 modulation for the same number of 
subscribers, is 

𝑅

σ 

=2,3â‹…10

9

 bps. 

 The calculated percentage of losses due to antinoise code rates reduction is only 

11.5%. Since the percentage is small, and given the fact that DVB-T2 uses just not all 
the possible MCS combinations, it is necessary to exclude some of them in when design 
two-way mobile MSDS. 

 

Figure 8. Radiuses of modulation considering reduction parameters 

Source: developed by the author 

 

So, by using the unique DVB-T2 tools for full-duplex communication system [21-

22], it is possible to achieve the best energy performance and productivity. Based on 
the calculated metrics of 24 possible MCS combinations, only seven of them selected 
for MSDS through rational reduction. Namely, these are the following combinations:  
QPSK with a code rate 1/2, QAM-16 with code rate 3/5, 3/4 and 4/5, QAM-64 with 
code rates 3/5, 3/4 and 5/6. With all of this, the percentage of losses due to tools 
reduction is only 11.5%, while system complexity reduced much significantly. 

 

CONCLUSION 

Modern society strives to meet their own needs by obtaining information through 

high-speed transmission and reliability, so the problem is quite acute in resource-

- 591 -